DKJ10-25/DKJ35-50/ 50-70 Red Welding Cable Quick Connector | Male Plug & Female Socket for Welder Cable Connection

Material Introduction

DKJ10-25/DKJ35-50/DKJ50-70 Red Welding Cable Quick Connector Set, compatible with 35mm² to 50mm² welding cables. Quick plug and pull design for fast cable connection and extension. Solid brass conductor ensures stable power transmission. Red reinforced rubber housing offers reliable insulation protection. Widely used for MMA, ARC welding machines on construction and workshop sites.

The DKJ10-25/DKJ35-50/DKJ50-70  welding cable connector adopts high purity brass conductive parts. Brass has excellent electrical conductivity, low contact resistance, stable current transmission and good heat dissipation, which prevents overheating under continuous welding load.

The outer housing is made of thickened red reinforced insulating rubber. It features high insulation strength, oil resistance, wear resistance, impact resistance and anti-aging performance. It can effectively isolate current and protect the brass core from mechanical damage.

The built-in fixing bolts are high-strength steel. They tightly clamp the cable copper strands to ensure stable contact, avoid poor connection and heating caused by loose wiring.

User Instructions

1.Prepare 35-50mm² welding cable. Strip the outer insulation of the cable end, expose copper wire core with proper length.

2.Disassemble the red rubber shell, loosen the fixing screws on brass terminal. Insert the stripped copper core into the brass cavity, tighten the screws firmly to lock the cable.

3.Slide the red insulating rubber shell back and assemble onto the brass conductor. Complete assembly for both plug and socket separately.

4.Align the male plug and female socket, push straight to lock. Connection finished and ready for welding operation.

5.Disconnection: Hold the red rubber housing on both sides and pull directly to separate. Do not pull the cable to disconnect the connector.

6.Pre-use Inspection: Check if all screws are tightened and rubber shell is intact. Stop using immediately if rubber cracked or brass deformed.

7.Notes: Only for welding cable connection. Do not exceed rated working current. Keep away from water, moisture and corrosive chemicals.